Camaro Car Jack

Be the first.

Camaro car jack. Early Holden jack in good working condition Pick up Melbourne Victoria or postage is available if needed anywhere in Australia. He custom ordered it through Dave Bean at Baldwin Chevrolet in Baldwin NY and Joel Rosen and Motion Performance built it. LH LX TORANA CENTRE CONSOLE LID ARMREST.

Holden Torana LH-LX Original Passenger Side Stainless Sill Panel Trim. Then I slowly jack each side up and put a stand under the front ones as well. They fit the 6th gen Camaro and 1617 Cadillac plus many other cars.

It would cost between 20 and 50 euros to buy them here is a simple and. After very much research I have found that cars from the West Coast Van Nuys Ca for the Camaro generally have the square cross sectional type tube shaft made by the Walker Manufacturing Co. PROTECTS Car Under-body from dents punctures and bends from standard floor jacks.

I just assumed the last 9 was just rubbed off as the hook looks to be well used. This form of jack is not standard equipment on vehicles and is usually only provided with a premium model or bought in car centres. I am looking for a correct bumper jack shaft assembly for a 70 Camaro made in Van Nuys dated March or April 1970.

The grille is the correct width and height and everything we dont even modify it. Protects Car Jack from Damaging Tesla Battery4pcs Black 46 out of 5 stars 142. This limited quantity jack kit comes with an original General Motors stamped Jack Mast.

After I got the detail in the engine bay done he put his car in the Camaro Natz here in the Detroit area Ann Arbor I think it was He got marked down huge for having an empty trunk. 1 Set 1 Mag Pad Mag Puck 2 Sets 2 Mag Pads 2 Mag Pucks. Here is a picture of a camaro on a lift put your stands in the same locations this will allow the suspension to hang down taking the weight off the springs.